Hi friends,
I did a lot of research on the forum and i couldnt find exact solution about immobilizer - ecu matching.
I need your advise to solve this problem.
I bought a new ECU (MR539772) after my car's ECU broke ( no power on Coils) but my car doesnt work with the new ecu.
I have MUT III with VCI adapter and i registered the key via MUT III.
Ecu gives trouble code P1610 (immobilizer system error code) and no power on injectors.
- İmmobilizer ecu is working well because when i swap the ecu with old one, there is power on injectors.
- i tried the method that "wait 35min ignition on with unregistered key then register it"
- when i try to enter "vin write / read" menu in MUT III then system says " this function not supported".
Is there any way to solve this matching problem using MUT III or should i swap ecu processor from old to new one.
thank you for your suggestions.
Pajero IO / Pinin, immobilizer - ecu matching, which way should i choose, swap processor or ecu reflash? (mh8201f)
Moderator: Bad-Teo
Re: Pajero IO / Pinin, immobilizer - ecu matching, which way should i choose, swap processor or ecu reflash? (mh8201f)
You need to read rom from old ecu and flash it to new one.
In backup we trust.
Re: Pajero IO / Pinin, immobilizer - ecu matching, which way should i choose, swap processor or ecu reflash? (mh8201f)
Easiest way if you take an ecuflash with openport 2.0.
But I don’t know cpu model inside, so possible ecuflash can’t help.
But I don’t know cpu model inside, so possible ecuflash can’t help.
In backup we trust.