Hello everyone!
I'm so glad I found this wonderful forum!
Of course I also have one question: how to make KTS 590 work with MUT 3 and MUT 3 SE?! I have installed the driver to work in Passthru (J2534) mode from the Bosch site, the firmware in the KTS is updated, but the Mitsubishi software does not want to "see" it. What else needs to be done?!
Sorry if I messed up the place for my post.
Thank you all for your support!!!!
M.U.T 3 / M.U.T 3 SE & KTS 590 - HELP!
Re: M.U.T 3 / M.U.T 3 SE & KTS 590 - HELP!
Hi. Need to buy special driver https://forum.kolyandex.su/viewtopic.php?f=14&t=21
In backup we trust.
Re: M.U.T 3 / M.U.T 3 SE & KTS 590 - HELP!
Thanks for the quick response!!!!
Does the purchase guarantee that KTS will work at least as a diagnostic or can it also be used for Coding Writer?!
Does the purchase guarantee that KTS will work at least as a diagnostic or can it also be used for Coding Writer?!
Re: M.U.T 3 / M.U.T 3 SE & KTS 590 - HELP!
Check with unregistered version https://forum.kolyandex.su/viewtopic.php?f=14&t=16
It should connect to engine ECU.
It should connect to engine ECU.
In backup we trust.
Re: M.U.T 3 / M.U.T 3 SE & KTS 590 - HELP!
It doesn't work. It does not connect to any electronic unit.
The idea is not to use Codingwrit with KTS. I wаnt to do diagnostics using the official software (MUT-) and KTS-590 adapter just like using the official V.C.I., Is this even possible and how?!
The idea is not to use Codingwrit with KTS. I wаnt to do diagnostics using the official software (MUT-) and KTS-590 adapter just like using the official V.C.I., Is this even possible and how?!