FAQ in english

[kolyandex]

Only errors are asc systm issue and 4wd issue, However those errors were there before key programming. Is there an option in the MUT III to check to see if the key is present and working? should I try programming again? just not sure if that will work as it would be considered a used key now and it would be able to be reprogrammed, or am I incorrect?

Hm. Try to manually turn on starter relay, if all ok, engine will started.

[kernel]

Only errors are asc systm issue and 4wd issue, However those errors were there before key programming. Is there an option in the MUT III to check to see if the key is present and working? should I try programming again? just not sure if that will work as it would be considered a used key now and it would be able to be reprogrammed, or am I incorrect?

Hm. Try to manually turn on starter relay, if all ok, engine will started.

It now turns over, I had to trace the starter line and found the issue, It had nothing to do with the driver or MUT III. Thank you for all your help.

[Paulo_evo]

So, the most complete package costs US$ 160,00, is it correct? 150 USD for version 3 + 10 USD for add-on for Nippon Seiki meters with MB91F223 CPU (read/write EEPROM, only for version 3)?

[kolyandex]

So, the most complete package costs US$ 160,00, is it correct? 150 USD for version 3 + 10 USD for add-on for Nippon Seiki meters with MB91F223 CPU (read/write EEPROM, only for version 3)?

Yep

[kolyandex]

I'm guessing the emulator currently does not support kline with any vehicle pre 2000?
Is this something that will be added in the future?
I'm wanting to use mut-iii to be able to view fault codes with the srs airbag system, but my car is a 1998 RVR sportsgear x3 im guessing the above means it wont work with my car

Do you have schematics for that car?
Original VCI-Lite can operate only with CAN and k-line without support old protocols, that's why it impossible.

[kolyandex]

Can you take a photo of OBD connector wires side?

[kolyandex]

Try to use trial version and connect to engine ECU viewtopic.php?f=14&t=16

[kolyandex]

Not engine tab. Use MUT-3 SE like this:

rgv.png

[megaaxel]

is there a download link for MUT-3 SE?

http://mmc-forum.ru/viewtopic.php?p=1173#p1173

[kolyandex]

Not engine tab. Use MUT-3 SE like this:

I get this error with the demo driver:
20200805_221624.jpg

Download file from first topic message. Current version you use is a very old and not supported by new MUT.
download/file.php?id=138