Hello
I am new to this Mitsubishi Flasher tool. I have Mitsubishi Lancer ecu. MH8306F K-line. I try to read via Openport 2.0 with Aux Boot pin but reading flash. the tool not not provide details clearly how to connect Boot Pin. I wrote email to moderator but not yet reply from him. I need to know How to connect this K-Line ecu for read and write
Mitsubishi Lancer MH8306F Not Reading
Mitsubishi Lancer MH8306F Not Reading
- Attachments
-
- m1 (2).jpeg (264.62 KiB) Viewed 150 times
-
- m1 (1).jpeg (360.8 KiB) Viewed 150 times
-
- errrr.PNG (53.01 KiB) Viewed 150 times
Re: Mitsubishi Lancer MH8306F Not Reading
Possible ecu with some kind of protection.
Wires connection correct.
Wires connection correct.
In backup we trust.
Re: Mitsubishi Lancer MH8306F Not Reading
Hello
Same ecu connection I read with mmcflasher / Alex Flasher / Pcmflash clone also read ecu well. only your this tool not read. Open port 2.0 + AUX Boot pin ok for your this tool ?
I think your tool not good
Same ecu connection I read with mmcflasher / Alex Flasher / Pcmflash clone also read ecu well. only your this tool not read. Open port 2.0 + AUX Boot pin ok for your this tool ?
I think your tool not good